This is an shortwave QRP SSB/CW trnasceiver, it adopt 1602 screen and with built-in battery, also comes with the recharger for you to use together. With powerful functions such as CW decoding, 8 bands, full bands support and so on. If you need it, come and have a try, it will not let you down.
Features:
This transceivers adopt IRF series launching tube and can be used by connecting the antenna (M seat).
Full mode support: USB, LSB, CW, AM, FM. Multi-band support, continuously adjustable in the 160m-10m frequency band (and performance loss from 20kHz..99MHz)
DSP filter: 4000, 2500, 1700, 500, 200, 100, 50Hz passband and with powerful DSP functions: automatic gain control (AGC), noise reduction (NR), voice trigger, voice trigger Xmit, RX attenuator attenuator (ATT), TX noise gate, TX driver control, volumes control, dBm/S-meter.
Software-based voice trigger Xmit can be used as a quick full invasive (QSK and semi-QSK operation), or to assist in running in digital mode (without C-AT or PTT interface) for RX/TX switching, external PTT output with TX/PA control-delay.
Thanks to EER transmitters E-level, it has high power efficiency (no bulky heat sink required), and simple design (no need for complex balanced linear power amplifiers).
SSB transmitters stage based entirely on digital and software: By controlling the phase of the SI5351 PLL (via the tiny frequency change of I2C over 800kbit/s) and the amplitude of the PA (via the PWM of PWM) to sample the microphone input and reconstruct the SSB signal. PA keys shaping circuit).
Fully digital and software-based SDR receiver stage (optional): sample the I/Q (complex) signal from the quadrature sampling detector digital mixer, and perform a 90-degree phase shift in the software (Hilber transform) and eliminate one by adding sidebands.
Fully digital and software-based SDR receiver stage (optional): sample the I/Q (complex) signal from the quadrature sampling detector digital mixer, and perform a 90-degree phase shift in the software (Hilber transform) and eliminate one by adding sidebands.
Specifications:
Material: Aluminum
Plug: EUPlug, USA plug (optional)
Receiver noise level MDS: -135 dBm (200Hz BW) at 28MHz
Receiver front-end selectivity: steep tuning frequency -45dB / ten times roll-off ±2kHz
Blocking dynamic ranges: 20kHz offset 123dB, 2kHz offset 78dB
Rf output: 10W max at 13.8V exit direct current in(Positive is the center)
Frequency ranges: 3.5-30MHz
Antenna/connector: 50ohms/SO-239
Battery: 1 * lithium battery, 3600mAh (included)
Package size: 180 * 120 * 80mm / 7.1 * 4.7 * 3.1in
Package weight: 754g / 1.7lb
Packing list:
1 * Transceivers
1 * Power Adapter (Optional)
1 * Microphone